Abstract
Ocean thermal energy conversion (OTEC) is a potential source of renewable energy. In order to design a turbine for maximizing the output power for very low working temperature application like OTEC, careful one-dimensional design followed by detailed three dimensional simulation is required. In this work a radial-inflow turbine with R-22 as working fluid is designed for a closed-cycle ocean thermal energy conversion plant of 2 kWe capacity. Design speed of the turbine is 34000 rpm. Inlet and outlet temperatures of designed turbine are 24.5 °C and 14 °C respectively. Three-dimensional fluid flow analysis inside the turbine at design and off-design conditions were carried out. Important dimensions of the turbine are: rotor tip and shroud radii of 24 mm and 19 mm respectively; blade widths at rotor inlet and outlet of 6 mm and 11 mm respectively; axial length of 17.5 mm; diffuser of 62 mm long. Volute casing designed has a circular cross section. The importance of the number of blades, blade filleting and stagger angle from the point of view of turbine performance are reported.